Constructing a Slot&Fix planter
Tools required
1.
Slot panels into legs and, using the large screws provided, fix the four legs onto two of the panels.
2.
Slot the remaining two panels into the legs and fix.
3.
When the planter is in the required position place the base inside (do not fix). To make the planter square measure as shown below, adjust as necessary to make the two measurements correspond.
For raised-beds etc (where a base is not required) ground boards can be screwed to the inside of the planter.
4.
Position the four wooden corner braces (as shown below) and using the screws provided fix to the planter and then the base.
5.
Finally, place a pea size amount of exterior wood glue (not supplied) on the top centre of each leg then screw the leg finials into the top of each leg.
Pay just! £12.95 carriage on order total (Time limited offer)
Height measurements are from bottom of leg to planter top rail.
Delivery within 21 days
